Teknofay Ex Rapid Fast Setting Ceramic Adhesive

Product description
Cement-based, high performance, flexible, fast-hardening ceramic adhesive mortar with reduced slip.

Usage areas
• In indoor and outdoor applications,
• Bonding of materials such as granite, ceramic, marble and natural granite,
• In applications on gypsum plaster, gypsum panel, gas concrete and exposed concrete,
• In the application of 40x40 cm and larger sized coating materials,
• In applications where there will be heavy pedestrian and freight traffic,
• Gives excellent results in ceramic and granite bonding works on exteriors,
• Bonding of natural stone, btb, glass mosaics,
• Swimming pool, water tank, Turkish bath, bathroom, etc. in wet volumes,
• Used in ceramic coating applications on old ceramics,
• It is ideal for use in places where it is desired to be opened in one day.

Features and Advantages
• It has high adhesion.
• It does not slip in vertical applications.
• Easy to prepare and apply.
• It is resistant to water, humidity and freezing.
• Processing time is long.
• It does not slip in vertical applications.
• Thanks to its fast setting feature, it gains strength after 6 hours.
• Allows joint filling process after 3-4 hours.

Application Instructions
Surface Quality: Surfaces should be clean, smooth, solid and at the same time in balance, weak parts should be removed and damaged surfaces should be repaired with TEKNOREP. The surface should be free of oil, dirt and rust.

Surface Preparation: If the application will be made on marble, ceramic and palletite, the surfaces should be roughened. The concrete floor should be moist but not puddled.

Mixing: Take 6.0-6.5 lt. clean, clear water is poured. Teknofay Ex Rapid, which is in a 25 kg bag in powder form, is poured into the container filled with water. It is mixed with a low-speed mixer with a ceramic mixer tip attached until a homogeneous mixture without lumps is obtained. Mixing time is minimum 5 minutes. should be. The mortar obtained at the end of the process takes 3 minutes. rest and again for 2 minutes. should be mixed until it becomes homogeneous. In ceramic applications on ceramics, 40x40 cm. It should be preferred to use the combined bonding method in the coating of larger sized coating materials. Tiles should be adhered by applying force, preferably with a rubber hammer, on the notched mortar within 15 minutes.

Application Notes / Limitations
• The product may cause irritation in contact with the skin. Work clothes, protective gloves, masks and goggles should be used. Before starting work, a protective cream can also be applied to the hand. In case of contact with the eyes, the eyes should be immediately washed with warm water and a doctor should be consulted.
• It must be protected under (+) 5°C ambient conditions, it must be covered with nylon or heat insulation plates must be laid to prevent the product from being exposed to frost.
• It must be protected at temperatures above (+) 35 °C, it must be covered with nylon or heat insulation plates must be laid to prevent the product from being exposed to sudden water loss.
• Joint filling should be started 24 hours after Teknofay Ex Rapid application.
• Do not add foreign matter.
• After the application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost. Cleaning should be done with water before Teknofay Ex Rapid is fully cured and hardened. Immediately after the application, hands and face should be washed thoroughly with soap and warm water.
• Equipment should be washed with water immediately after the application, before the mortar hardens.

Storage conditions
It should be stored in its unopened original package, in a cool and dry environment, protected from frost.